Spin Time - GIRBAU HS-6013 Operation Instructions Manual

There are six programmable speeds during draining.
The speeds 4, 5 and 6 are modifiable in the CONFIGURATION menu.
Possible programming
Rotation speeds in rpm
Drain without
drum rotation
Drain
<<< Option
E1
programme
d by default
Drain +
E2
positioning
speed
Drain +
low spin E3
speed
Drain +
medium spin E4
speed
Drain +
medium/high E5
spin speed
Drain +
high spin E6
speed

7.3.16. Spin time

Programming this function is only possible if drain and rotation speed 2 or higher has been programmed.
Important!
Unlike other Girbau washer controls, INTELI control spin time countdown starts when the positioning
speed has been reached and the unbalance value is correct.
Programming the spin time in minutes (default option)
Programmable time range: 1–15 minutes
Value by default: depending on programmed spin cycle
Programming the spin time in seconds (optional programming)
INTELI control allows you to change the unit of time for spinning to be programmed in seconds. This function
only appears if EXTRACT TIME UNIT sec has been activated in the SETUP menu. This option is available on
models with microprocessor Version 21D/21F or later.
ATTENTION!! If changes in the unit of time are made in the settings, or programs from a card are used
with different units of time to those of the machine, spin times may suffer alterations.
Programming a new wash program
HS-6013 HS-6017 HS-6023
EH030 EH040 EH055
Rotation sequence and washing speed programmed in wash
phase. Draining time non programmable
100 100
400 375 330
600 570 525
800 750 725
1000 950 920
HS-6024 HS-6032
EH060 EH080
Without rotation
87 86 83
350 335
550 530
725 698
966 931
HS-6040 HS-6057 HS-6110
EH090 EH130 EH225
79 72 66
325 300 250
490 450 405
680 625 565
870 800 725
Code 429159
Rev. 15/0717
44