Selecting Phase And Intervention; Modifying And Viewing The Content Of A Phase - GIRBAU HS-6013 Operation Instructions Manual

8.1.2. Selecting phase and intervention

PROG. 43
PHAS 1 2 3 4 5 6 7 8 9
 
PROG. 43
PHAS 1 2 3 4 5 6 7 8 9
 

8.1.3. Modifying and viewing the content of a phase

Permits viewing, and modifying if desired, the content of the phase selected. Modifying the parameters will only
be possible in programs recorded by the user.
The programming limits of the different operations are the same as those defined in the corresponding sections
of the PROGRAMMING menu.
Select the icon and confirm the selection.
From this moment on, the same screens used during programming a new program will appear.
The program and the phase being modified appear in the upper, central box.
Modifying the operations will be done following the same steps as those in section 7.3 as well as the following
ones.
To finalize the modification of the content of the phase, accessing the end of phase screen (7.3.18) is
imperative.
Modifying programs
16:35
OK

16:36
OK

Select the phase that you want to modify. Confirm
the selection.
The following screen appears.
Options for modifying a phase
Modifying or viewing the content of the phase

(8.1.3)
Inserting a phase before the phase selected (8.1.4)

Inserting a phase after the phase selected (8.1.4)

Erasing a phase (8.1.5)

Select the desired action and confirm the selection.
51
Code 429159
Rev. 15/0717