Cleaning The Solenoid Valve Filters; Verifying The Safety Mechanisms - GIRBAU HS-6013 Operation Instructions Manual

15.3. Cleaning the solenoid valve filters

Only by qualified personnel.
Required tools:
 Disassembly of the fittings: slip-joint pliers or pipe wrench 35 mm.
 Disassembly of the filter supports: wrench 34 mm.
 Disassembly of the filters: pliers.
Steps to follow
 Disconnect and mechanically lock the external switch. Close and mechanically interlock the manual
water supply valves.
 Check the temperature of the hot water inlet hose, so as to avoid the risk of burns.
 Disassemble the fittings that connect the hoses to the washing machine.
 Disassemble the filter supports.
 Remove the filters from their housings and clean the filters with pressurised water. Place them back into
their housings.
 Assemble the supports to the electrovalves.
 Assemble the hoses in their corresponding inputs. Tighten the fittings.
 Connect the external switch, open the manual water input valves and check the water tightness of the
coupling.

15.4. Verifying the safety mechanisms

Verifying the door lock
DAILY check the safety mechanism on the door lock.
CAUTION. Only by qualified personnel
Use great prudence in checking the safety mechanisms.
Carry out the verification described in following while the drum is turning at washing speed and never at a
higher speed.
If there is a failure in the door lock, never place one's hand in the loading area of the washer.
Verification procedure:
 Disconnect the ON switch. The washing machine screen is off.
 Close and mechanically interlock the manual water supply valves (and steam inlet valve in washers with
this option included.)
 Open the washing machine door.
 Connect the ON/OFF switch. On the screen the door open icon is displayed.
 Close the door. Select and start a wash cycle.
 After about a minute from starting the cycle, check that the door is locked.
 Press the STOP key to finish the verification.
 After a safety delay of no more than 30 seconds, the door will be unlocked.
 The verification is finished.
 If no anomaly has been detected, open the fluid inlet valves.
CAUTION
If noticing anything other than what was described during the operation, disconnect the washer, do not use it,
and URGENTLY contact the Authorised Technical Service.
Maintenance
78
Code 429159
Rev. 15/0717