Disassembling Rear Axle; Servicing - Kubota L2800 Workshop Manual

L2800, L3400, WSM

[2] DISASSEMBLING REAR AXLE

Rear Axle

[3] SERVICING

Tractor Manuals Scotland - Please Do Not Copy
Tractor Manuals Scotland
1. Remove the ball bearing (9) with a puller.
2. Remove the stake of lock nut (8).
3. Secure the rear axle (1) in a vise and remove the lock nut.
4. Take out the gear (7) and spacer (5).
5. Tap out the rear axle (1).
(When reassembling)
• Apply grease to the oil seal (2) and install it.
• Replace the lock nut with new one, and after tightening it to
specified torque, stake it firmly.
• Assemble the oil seal (2) with correct direction. (See figure on
the left.)
Tightening torque
Checking Bearing
1. Hold the inner race, and push and pull the outer race in all
directions to check for wear and roughness.
2. Apply transmission fluid to the bearing, and hold the inner race.
Then turn the outer race to check rotation.
3. If there is any defect, replace it.
4-S5
(1) Rear Axle
(2) Oil Seal
(3) Internal Snap Ring
(4) Ball Bearing
(5) Spacer
(6) Rear Axle Case
(7) Gear
(8) Lock Nut
(9) Ball Bearing
(10) Ball Bearing
196 to 245 N·m
Lock nut 20 to 25 kgf·m
145 to 181 ft-lbs
REAR AXLE
W1011594
W1011681
W1011912
KiSC issued 08, 2007 A