Preparation; Separating Engine And Clutch Housing - Kubota L2800 Workshop Manual

L2800, L3400, WSM

[2] PREPARATION

(1) Separating Engine and Clutch Housing

Tractor Manuals Scotland - Please Do Not Copy
Tractor Manuals Scotland
Draining the Transmission Fluid
1. Place an oil pan underneath the transmission case.
2. Remove the drain plugs (1) at the bottom of the transmission
case.
3. Drain the transmission fluid.
4. Screw in the drain plugs (1).
(When reassembling)
• Fill up new oil to the upper line of the gauge (2) from the filling port
after removing the filling plug (3).
• After running the engine for a few minutes, stop it and check the
fluid level again, if low, add fluid prescribed level (A).
IMPORTANT
• Use only multi-grade transmission fluid. Use of other fluides
may damage the transmission or hydraulic system.
• Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-7.)
• Never work the tractor immediately after changing the
transmission fluid. Keeping the engine at medium speed for
a few minutes to prevent damage to the transmission.
• Do not mix different brands oil together.
Transmission fluid
(1) Drain Plug
(2) Gauge
(3) Filling Plug
Bonnet and Front Cover
1. Disconnect the battery negative cable.
2. Disconnect the connector for head light.
3. Remove bonnet (1) and side cover (2).
4. Remove the front cover (3).
(1) Bonnet
(2) Side Cover
2-S7
27 L
2WD 7.1 U.S.gals
5.98 Imp.gals
27.5 L
Capacity 4WD 7.3 U.S.gals
6.1 Imp.gals
23.5 L
HST
6.2 U.S.gals
(4WD)
5.2 Imp.gals
A : Oil level is acceptable within this
range.
(3) Front Cover
CLUTCH
W1015970
W1016314
KiSC issued 08, 2007 A