L2800, L3400, WSM
Tractor Manuals Scotland - Please Do Not Copy
Tractor Manuals Scotland
Bevel Gear Case, Axle Flange and Front Gear Case
1. Remove the plug (4).
2. Remove the internal snap ring (3) and shim (2).
3. Remove the axle flange (1).
4. Tap out the bevel gear (6) and ball bearing.
5. Draw out the bevel gear shaft (7).
6. Remove the external snap ring (5).
7. Tap the bevel gear case (8), and separate it from the front gear
case (9).
(When reassembling)
• Apply grease to the O-rings of axle flange (1).
• Tighten the axle flange mounting screws and nuts diagonally in
several steps.
• Install the oil seal (10) of bevel gear case, noting its direction as
shown in the figure below.
Tightening torque
(1) Axle Flange
(2) Shim
(3) Internal Snap Ring
(4) Plug
(5) External Snap Ring
6-S13
11.8 to 15.7 N·m
Axle flange mounting stud
1.2 to 1.6 kgf·m
bolt
8.7 to 11.5 ft-lbs
23.6 to 27.4 N·m
Axle flange mounting
2.4 to 2.8 kgf·m
screws and nuts
17.4 to 20.2 ft-lbs
(6) Bevel Gear
(7) Bevel Gear Shaft
(8) Bevel Gear Case
(9) Front Gear Case
(10) Oil Seal
FRONT AXLE
W1015238
KiSC issued 08, 2007 A