Kubota L2800 Workshop Manual page 34

L2800, L3400, WSM
Tractor Manuals Scotland - Please Do Not Copy
Tractor Manuals Scotland
Replacing Hydraulic Oil Filter (Manual Transmission Type)
CAUTION
• Be sure to stop the engine before changing the oil filters.
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Place an oil pan under the tractor.
2. Remove the drain plugs (1) at the bottom of the transmission
case.
3. Drain the transmission fluid.
4. After draining, screw in the drain plugs.
5. Remove the oil filter cartridge (4) by using a filter wrench.
6. Make sure the mounting surface is clean.
Put a film of clean transmission fluid on the rubber seal of the new
filter.
7. Install the new filter cartridge.
8. Quickly tighten the filter until it contacts the mounting surface,
then tighten it by hand an additional 1/2 turn only.
9. After the new filter have been replaced, fill with oil up to the upper
line of the gauge (2).
10.After running the engine for a few minutes, stop it and recheck
the oil level, add oil to the prescribed level.
11.Make sure that the transmission fluid doesn't leak through the
seal of the filter.
IMPORTANT
• To prevent serious damage to the hydraulic system. Use
only a genuine KUBOTA filter or its equivalents.
(1) Drain Plug
(2) Gauge
(3) Filling Plug
(4) Hydraulic Oil Filter
G-17
G GENERAL
A : Oil level is acceptable within this
range.
(A) 2WD Type
(B) 4WD Type
W1015586
KiSC issued 08, 2007 A