L2800, L3400, WSM
Tractor Manuals Scotland - Please Do Not Copy
Tractor Manuals Scotland
Bumper and Tie-rods
1. Place the disassembling stand under the transmission case.
2. Remove the bumper.
3. Remove the tie-rods with the tie-rod end lifter.
In this case, take special case not to damage the tie-rod end nut
(slotted nut). (It is preferable to replace it with an unrequired
nut.).
4. Reinstall the bumper.
(When reassembling)
Tightening
torque
IMPORTANT
• After tightening the tie-rod end nut to the specified torque,
install a cotter pin as shown in the figure left.
(1) Tie-rod
Delivery Pipe and Return Hose
1. Remove the battery and shutter plate.
2. Disconnect the power steering delivery pipe (1) and return hose
(2).
(When reassembling)
Tightening torque
(1) Delivery Pipe
Steering Gear Box Assembly
1. Remove the steering gear box mounting screws.
2. Remove the steering gear box (1).
(When reassembling)
Tightening torque
(1) Steering Gear Box
7-S5
2WD
Tie-rod end nut
4WD
(2) Pitman Arm
Delivery pipe joint bolt
(2) Return Hose
Steering gear box
mounting screw
STEERING
49.0 to 68.6 N·m
5.0 to 7.0 kgf·m
36.2 to 50.6 ft-lbs
39.2 to 45.1 N·m
4.0 to 4.5 kgf·m
28.9 to 33.3 ft-lbs
W1020549
34 to 39 N·m
3.5 to 4.0 kgf·m
25.3 to 28.9 ft-lbs
W1020862
77.5 to 90.2 N·m
7.9 to 9.2 kgf·m
57.2 to 66.5 ft-lbs
W1020988
KiSC issued 08, 2007 A