Crankshaft - Kubota L2800 Workshop Manual

L2800, L3400, WSM

(4) Crankshaft

Tractor Manuals Scotland - Please Do Not Copy
Tractor Manuals Scotland
Flywheel
1. Fit the stopper to the flywheel (1).
2. Remove the all flywheel screws (2).
3. Remove the flywheel (1) slowly.
(When reassembling)
• Insert two pieces of the flywheel guide screws.
• Check to see that there are no metal particles left on the flywheel
mounting surfaces.
• Apply engine oil to the threads and the undercut surface of the
flywheel bolt and fit the bolt.
Tightening torque
(1) Flywheel
Bearing Case Cover
1. Remove the bearing case cover mounting screws. First, remove
inside screws (2) and then outside screws (3).
2. Remove the bearing case cover (1).
IMPORTANT
• The length of inside screws and outside screws are
different. Do not take a mistake using inside screws and
outside screws.
(When reassembling)
• Fit the bearing case gasket (5) and the bearing case cover gasket
(6) with correct directions (b).
• Install the bearing case cover to position the casting mark "UP"
(a) on it upward.
• Apply engine oil to the oil seal lip and take care that it is not rolled
when installing.
• Tighten the bearing case cover mounting screws with even force
on the diagonal line.
Tightening torque
(1) Bearing Case Cover
(2) Bearing Case Cover Mounting Screw
(3) Bearing Case Cover Mounting Screw
(4) Oil Seal
1-S37
98.0 to 107.8 N·m
Flywheel screws 10.0 to 11.0 kgf·m
72.3 to 79.5 ft-lbs
(2) Flywheel Screw
23.5 to 27.5 N·m
Bearing case cover
2.4 to 2.8 kgf·m
mounting screw
17.4 to 20.3 ft-lbs
(5) Bearing Case Gasket
(6) Bearing Case Cover Gasket
(a) Mark "UP"
(b) Upside
ENGINE
W1026863
W10292140
KiSC issued 08, 2007 A