Combination Switch - Kubota L2800 Workshop Manual

L2800, L3400, WSM

(9) Combination Switch

Tractor Manuals Scotland
Remove the Combination Switch
1. Remove the panel board (1), and disconnect the combination
switch connector 8A (3) after turning the main switch OFF
position.
2. Perform the following checkings.
(1) Combination Switch
(2) Panel Board
Conector Voltage
1. Disconnect the connector 8A from the combination switch.
2. Measure the voltage with a voltmeter across the connector B1
terminal and chassis when the main switch is OFF position.
3. If the voltage differs from the battery voltage, the wiring harness
is faulty.
4. Measure the voltage with a voltmeter across the connector B2
terminal and chassis when the main switch is ON position.
5. If the voltage differs from the battery voltage, check the wiring
harness and main switch.
Voltage
(A) Wire Harness Side Connector 8A
Tractor Manuals Scotland - Please Do Not Copy
9-S18
(2) Combination Switch 8A Connector
Main switch at "OFF"
B1 terminal – Chassis
position
Main switch at "ON"
B2 terminal – Chassis
position
ELECTRICAL SYSTEM
W10207990
Battery
voltage
W1073019
KiSC issued 08, 2007 A