Kubota L2800 Workshop Manual page 189

L2800, L3400, WSM
Tractor Manuals Scotland
Main Shaft Case
1. Remove the main shaft case (1).
2. Remove the stopper plate (2).
3. Remove the bearing cover (3).
(When reassembling)
• Apply grease to the O-ring and install it to the clutch housing.
• After reassembling the main shaft case, check that 16T gear
shaft (4) and main shaft (5) rotate respectively and that they have
a little axial play.
• Bearing cover (3) should be replaced with new one.
(When replacing bearing and oil seal in main shaft case)
• Install the oil seal (6) as shown in the figure, noting its direction.
• Apply grease to the needle bearing (7) and press-fit it up to the
groove of internal snap ring (8).
(1) Main Shaft Cover
(2) Stopper Plate
(3) Bearing Cover
(4) 16T Gear Shaftt
Counter Shaft
1. Remove the bolt (1) and take out the spring and ball.
2. Tap out the spring pin (2).
3. Draw out the fork rod (3) to the front and take out the shift fork (4)
and balls.
4. Remove the snap ring (11), (12).
5. Tap out the counter shaft (13) to the rear.
NOTE
• When drawing out the counter shaft, take out the following
parts one by one: thrust collar (6), 32T gear (10), 38T gear (8)
and 45T gear (9) and 45T gear (10).
(When reassembling)
• Apply molybdenum disulfide (Three Bond 1091 or equivalent) to
the inner circumferential surface of the spline boss.
• Point the oil groove side of thrust collar (6) towards the spline
boss.
• With the snap rings in position, make sure that the 32T and 45T
gears turn smoothly.
(1) Bolt
(2) Spring Pin
(3) Fork Rod
(4) Shift Fork
(5) Bearing
(6) Thrust Collar
(7) 32T Gear
Tractor Manuals Scotland - Please Do Not Copy
3-S16
TRANSMISSION (MANUAL TYPE)
(5) Main Shaft
(6) Oil Seal
(7) Needle Bearing
(8) Snap Ring
(8) 41T Gear
(9) 45T Gear
(10) 45T Gear
(11) Snap RIng
(12) Snap RIng
(13) Counter Shaft
W1014893
W1015187
KiSC issued 08, 2007 A