Kubota L2800 Workshop Manual page 271

L2800, L3400, WSM
Tractor Manuals Scotland
ROPS
1. Remove the ROPS upper frame (1).
2. Remove the ROPS lower frame (2).
(When reassembling)
Tightening torque
(1) ROPS Upper Frame
(2) ROPS Lower Frame
Rear Wheel and Rear Fender
1. Disconnect the battery negative cable.
2. Place the disassembling stand under the transmission case.
3. Loosen and remove the rear wheel mounting screws and nuts.
4. Remove the rear wheel (3) and rear fender (1).
5. Remove the grip (2).
(When reassembling)
Tightening torque
(1) Rear Fender
(2) Grip
Rear Axle Case
1. Loosen and remove the rear axle case mounting screws and
nuts.
2. Support the rear axle case (1) with the nylon lift strap and hoist.
3. Separate the rear axle case from brake case.
4. Follow the same procedure as above for the other side.
(When reassembling)
• Apply liquid gasket (Three Bond 1208D, 1141 or equivalent) to
joint face of the rear axle case and brake case, after eliminating
the water, oil and stuck liquid gasket.
Tightening torque
(1) Rear Axle Case
Tractor Manuals Scotland - Please Do Not Copy
5-S6
167 to 196 N·m
ROPS mounting screw 17.0 to 20.0 kgf·m
123 to 144 ft-lbs
118 to 137 N·m
ROPS fulcrum screw 12 to 14 kgf·m
87 to 101 ft-lbs
(3) ROPS Fulcrum Screw
197 to 226 N·m
Rear wheel mounting
20 to 23 kgf·m
screw and nut
145 to 166 ft-lbs
(3) Rear Wheel
Rear axle case 48.1 to 55.9 N·m
mounting screws and 4.9 to 5.7 kgf·m
nuts 35.4 to 41.2 ft-lbs
24.5 to 31.4 N·m
Rear axle case
2.5 to 3.2 kgf·m
mounting stud bolt
18.1 to 23.1 ft-lbs
BRAKES
W1014459
W1011172
W1014849
KiSC issued 08, 2007 A