Kubota L2800 Workshop Manual page 248

L2800, L3400, WSM
Tractor Manuals Scotland - Please Do Not Copy
Tractor Manuals Scotland
PTO Clutch and Pinion Bearing Holder
1. Tap out the spring pin (6) and remove the screw (8), spring (3)
and lever (7).
2. Remove the PTO clutch cam (4) and shift fork (5).
3. Remove the pinion bearing mounting screws and bearing cover
(2).
4. Remove the lock nut (1).
5. Screw down the two M8 screws into the hole (A).
6. Remove the pinion bearing holder (10) and shim (9).
(When reassembling)
• Make sure of the number of shims in the pinion bearing holder.
• Replace the lock nut (1) with a new one, and stake the lock nut
firmly after installing the parts on the shaft.
Tightening torque
(1) Lock Nut
(2) Bearing Cover
(3) Spring
(4) PTO Clutch Cam
(5) Shift Fork
(6) Spring Pin
H3-S25
TRANSMISSION (HST TYPE)
147 to 196 N·m
Lock nut 15 to 20 kgf·m
109 to 145 ft-lbs
39.2 to 44.1 N·m
Pinion bearing holder
4.0 to 4.5 kgf·m
mounting screw
28.9 to 32.5 ft-lbs
(7) Lever
(8) Screw
(9) Shim
(10) Pinion Bearing Holder
(A) Hole
W1020909
KiSC issued 08, 2007 A