Adjusting Pto Wire; Preparation; Separating Engine And Clutch Housing - Kubota L2800 Workshop Manual

L2800, L3400, WSM

(6) Adjusting PTO Wire

[2] PREPARATION

(1) Separating Engine and Clutch Housing

Tractor Manuals Scotland
Adjusting PTO Wire
1. Check to see that the threaded portion of wire (3) rear side is set
at center position.
If not, set by lock nuts (2).
2. Set the PTO lever (1) at the OFF position (A).
3. The luck nut (4) is tightened in the direction of the arrow. Then
stop it before the lever (5) moves.
4. Retighten the lock nut securely.
(1) PTO Lever
(2) Lock Nuts (Rear Side)
(3) PTO Wire
(4) Lock Nuts Front Side)
(5) Lever
Draining the Transmission Fluid
1. Place an oil pan underneath the transmission case.
2. Remove the drain plugs (1) at the bottom of the transmission
case.
3. Drain the transmission fluid.
4. Screw in the drain plugs (1).
(When reassembling)
• Fill up new oil to the upper line of the gauge (2) from the filling port
after removing the filling plug (3).
• After running the engine for a few minutes, stop it and check the
fluid level again, if low, add fluid prescribed level (A).
IMPORTANT
• Use only multi-grade transmission fluid. Use of other fluids
may damage the transmission or hydraulic system.
• Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-7.)
• Never work the tractor immediately after changing the
transmission fluid. Keeping the engine at medium speed for
a few minutes to prevent damage to the transmission.
• Do not mix different brands oil together.
Transmission fluid
(1) Drain Plug
(2) Gauge
(3) Filling Plug
Tractor Manuals Scotland - Please Do Not Copy
H3-S12
TRANSMISSION (HST TYPE)
A : OFF Position
B : ON Position
23.5 L
Capacity 6.2 U.S.gals
5.2 Imp.gals
(A) Oil level is acceptable within this
range.
W1039856
W1012748
KiSC issued 08, 2007 A