4Wd Type Front Axle - Kubota L2800 Workshop Manual

L2800, L3400, WSM

(2) 4WD Type Front Axle

Tractor Manuals Scotland
Knuckle Shaft
1. Remove the knuckle arm (1) and draw out the knuckle shaft (4)
from the front axle.
(When reassembling)
• Insert the thrust ball bearing (2) and oil seal (3), noting its
direction.
• Apply grease to the oil seals (3), (6).
• Do not interchange right and left knuckle arms.
• When lift the knuckle shaft, the knuckle arms must be mounted
so that the clearance between the knuckle arms and front axle is
0.3 to 1.0 mm (0.012 to 0.039 in.).
Tightening torque
(1) Knuckle Arm
(2) Thrust Ball Bearing
(3) Oil Seal
(4) Knuckle Shaft
(5) Dust Cover
(6) Oil Seal
Bevel Gear Case and Front Gear Case
1. Remove the bevel gear case mounting screws.
2. Remove the bevel gear case (3) and front gear case (4) as a unit
from the front axle case (1).
(When reassembling)
• Apply grease to the O-ring (2) and take care not to damage it.
• Do not interchange right and left bevel gear case assemblies and
front gear case assemblies.
Tightening torque
(1) Front Axle Case
(2) O-ring
Tractor Manuals Scotland - Please Do Not Copy
6-S12
77.5 to 90.2 N·m
Knuckle arm mounting bolt
7.9 to 9.2 kgf·m
and nut
57.2 to 66.5 ft-lbs
(7) Ball Bearing
(8) Front Wheel Hub
(9) Spacer
(10) Ball Bearing
(11) Washer
(12) Slotted Nut
123.5 to 147.0 N·m
Bevel gear case mounting
12.6 to 15.0 kgf·m
screw
91.2 to 108.4 ft-lbs
(3) Bevel Gear Case
(4) Front Gear Case
FRONT AXLE
W1014597
W1015066
KiSC issued 08, 2007 A