Separating Clutch Housing From Mid Case - Kubota L2800 Workshop Manual

L2800, L3400, WSM

(2) Separating Clutch Housing from MID Case

Tractor Manuals Scotland
Separating Engine from Clutch Housing Case
1. Check the engine and clutch housing case are securely mounted
on the disassembling stands.
2. Remove the engine mounting screws, and separate the engine
from the clutch housing case.
(When reassembling)
• Apply grease to the splines.
• Apply liquid gasket (Three Bond 1208D or equivalent) to joint
face of the engine and clutch housing case.
Tightening torque
Hydraulic Pipes
1. Remove the suction pipe 1 (3) and pipe (2).
2. Remove the suction pipe 2 (8) with oil filter (9) and oil filter
bracket (7).
3. Remove the delivery pipe (10) and return pipe (1).
4. Remove the step support (4) with front hydraulic block.
5. Remove the HST neutral rod (6) and neutral holder arm (5).
(When reassembling)
• Be sure to adjust the HST neutral position. (See page H3-S10.)
• Install the copper washer securely.
Tightening torque
(1) Return Pipe
(2) Pipe
(3) Suction Pipe 1
(4) Step support
(5) Neutral Holder Arm
Steering Support Clutch Rods and Pipes
1. Remove the steering support (6).
2. Remove the oil filter (4) with bracket and pipes (3), (5).
3. Remove the step support (2) and clutch rods (1).
(When reassembling)
Tightening torque
(1) Clutch Rod
(2) Step Support
(3) Pipe
Tractor Manuals Scotland - Please Do Not Copy
H3-S16
TRANSMISSION (HST TYPE)
48.1 to55.8 N·m
Engine mounting screws to
4.9 to5.7 kgf·m
clutch housing
35.4 to41.2 ft-lbs
39.0 to 49.0 N·m
Delivery pipe (10) joint bolt 4.5 to 5.0 kgf·m
32.5 to 36.2 ft-lbs
49.0 to 69.0 N·m
Return pipe (1) joint bolt
5.0 to 7.0 kgf·m
and nut
36.1 to 50.6 ft-lbs
(6) HST Neutral Rod
(7) Oil Filter Bracket
(8) Suction Pipe 2
(9) Oil Filter
(10) Delivery pipe
77.5 to 90.2 N·m
Steering support mounting
7.9 to 9.2 kgf·m
screw
57.2 to 66.5 ft-lbs
(4) Oil Filter
(5) Pipe
(6) Steering Support
W1026299
W1013738
W1027455
KiSC issued 08, 2007 A