Servicing; 2Wd Type - Kubota L2800 Workshop Manual

Hide thumbs Also See for L2800:
Table of Contents

Advertisement

L2800, L3400, WSM

[4] SERVICING

(1) 2WD Type

Tractor Manuals Scotland - Please Do Not Copy
Tractor Manuals Scotland
Clearance between Front Axle Middle Boss and Shaft Bracket
Bushing
1. Measure the front axle middle boss O.D. at several points where
it contacts with the bushing.
2. Measure the shaft bracket 1 bushing I.D. and bracket 2 bushing
I.D. in the same method, and calculate the clearance.
3. If the clearance exceeds the allowable limit, replace them.
(When reassembling)
• Before press-fitting the bushing, install the new thrust collar.
• Install the oil seals, noting their direction. (Refer to figure left.)
IMPORTANT
• After replacing the bushing, be sure to adjust the front axle
rocking force. (See page 6-S7.)
Clearance between front
axle middle boss and
bushing
Front axle middle boss
O.D.
Bushing I.D.
(1) Thrust Collar
(2) Bushing
Clearance between Knuckle Shaft (Kingpin) and Bushing
1. Measure the shaft O.D. at several points where it contacts with
the bushings.
2. Measure the bushing I.D. in the same method, and calculate the
clearance.
3. If the clearance exceeds the allowable limit, replace the bushing.
(When reassembling)
• Remove the bushing with a bushing puller.
Clearance between
knuckle shaft (kingpin)
and bushing
Knuckle shaft O.D.
Bushing I.D.
6-S17
0.000 to 0.177 mm
Factory spec.
0.00000 to 0.00697 in.
0.3 mm
Allowable limit
0.012 in.
39.938 to 40.000 mm
Factory spec.
1.57236 to 1.57480 in.
40.000 to 40.115 mm
Factory spec.
1.57480 to 1.57933 in.
(3) Oil Seal
0.000 to 0.285 mm
Factory spec.
0.00000 to 0.01122 in.
0.4 mm
Allowable limit
0.016 in.
27.880 to 27.900 mm
Factory spec.
1.09764 to 1.09842 in.
27.900 to 28.165 mm
Factory spec.
1.09842 to 1.10886 in.
FRONT AXLE
W1017740
W1017976
KiSC issued 08, 2007 A

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

L3400

Table of Contents