Adjusting Neutral; Checking Cruise Lever Operating Force - Kubota L2800 Workshop Manual

L2800, L3400, WSM

(4) Adjusting Neutral

(5) Checking Cruise Lever Operating Force

Tractor Manuals Scotland
Adjusting Neutral
1. Disengage the front wheel drive lever. (Drive only rear wheels.).
2. Set the cruise control to "OFF" position. (HST pedal is neutral
position).
3. Check to see that the length (A) of HST neutral rod (5) is
specified length.
If not, adjust as follows
Length (A) : 73 to 74 mm (2.87 to 2.91 in.).
4. LIft the rear of the tractor so that the rear wheels are off thee
ground and run the engine at low idling and drive only rear
wheels.
5. Slightly loosen the plate mounting screws (4).
6. Press the neutral holder arm (3) to the plate (1).
7. Then rotate the neutral holder (2) clockwise or counter clockwise
until wheels stop completely.
8. Hold the neutral holder (2) and tighten the plate mounting screws
(4).
NOTE
• Be sure to tighten the plate mounting screw with specified
torque.
Tightening torque
(1) Plate
(2) Neutral Holder
(3) Neutral Holder Arm
(4) Screws
(5) HST Neutral Rod
Adjusting Cruise Control Rod
1. Set the cruise control lever to fully forward.
2. Adjust the cruise control rod (1) so that trunnion shaft may
maximum incline forward.
Length of cruise control
rod (A)
(1) Cruise Control Rod
Tractor Manuals Scotland - Please Do Not Copy
H3-S10
TRANSMISSION (HST TYPE)
23.6 to 27.4 N·m
Plate mounting screw 2.4 to 2.8 kgf·m
17.4 to 20.2 ft-lbs
A : Length
315 mm
Factory spec.
12.4 in.
(A) Length
W1033891
W1036351
KiSC issued 08, 2007 A