Disassembling And Servicing; Preparation - Kubota L2800 Workshop Manual

L2800, L3400, WSM

3. DISASSEMBLING AND SERVICING

[1] PREPARATION

Tractor Manuals Scotland - Please Do Not Copy
Tractor Manuals Scotland
Draining the Transmission Fluid
1. Place an oil pan underneath the transmission case.
2. Remove the drain plugs (1) at the bottom of the transmission
case.
3. Drain the transmission fluid.
4. Screw in the drain plugs (1).
(When reassembling)
• Fill up new oil to the upper line of the gauge (2) from the filling port
after removing the filling plug (3).
• After running the engine for a few minutes, stop it and check the
fluid level again, if low, add fluid prescribed level (A).
IMPORTANT
• Use only multi-grade transmission fluid. Use of other fluides
may damage the transmission or hydraulic system.
• Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-7.)
• Never work the tractor immediately after changing the
transmission fluid. Keeping the engine at medium speed for
a few minutes to prevent damage to the transmission.
• Do not mix different brands oil together.
Transmission fluid
(1) Drain Plug
(2) Gauge
(3) Filling Plug
Three Point Linkage
1. Remove the top link (1).
2. Remove the lift rod (2).
3. Remove the lower link (3).
(1) Top Link
(2) Lift Rod
4-S3
27 L
2WD 7.1 U.S.gals
5.98 Imp.gals
27.5 L
Capacity 4WD 7.3 U.S.gals
6.1 Imp.gals
23.5 L
HST
6.2 U.S.gals
(4WD)
5.2 Imp.gals
A : Oil level is acceptable within this
range.
(3) Lower Link
REAR AXLE
W1013525
W1012538
KiSC issued 08, 2007 A