Disassembling Rear Axle Case - Kubota M108S Workshop Manual

Hide thumbs Also See for M108S:

Table of Contents

(2) Disassembling Rear Axle Case

Planetary Gear Support

1. Remove the planetary gear support mounting UBS screw (1).

2. Remove the planetary gear support (2).

(When reassembling)

Planetary gear support

Tightening torque

mounting UBS screw

(1) Planetary Gear Support Mounting

Planetary Gear

1. Tap the spring pin (1) into the planetary gear shaft (3).

2. Draw out the planetary gear shaft (3), and remove the planetary

3. Tap out the spring pin (1) from the planetary gear shaft (3).

(When reassembling)

• Apply transmission fluid to the inner surface of planetary gear (2)

and bearing.

• Tap in the spring pin (1) as shown in the figure.

(1) Spring Pin

(2) Planetary Gear

1. Remove the rear axle cover mounting screw.

2. Hammer out the rear axle (1).

(When reassembling)

Rear axle cover mounting

Tightening torque

(1) Rear Axle

90.3 to 103 N·m

9.20 to 10.6 kgf·m

66.6 to 76.6 lbf·ft

(2) Planetary Gear Support

(3) Planetary Gear Shaft

78 to 90 N·m

7.9 to 9.2 kgf·m

58 to 66 lbf·ft

(2) Rear Axle Cover

KiSC issued 06, 2007 A

Table of Contents