Displaying The Dhcp Relay Configuration For A Vlan; Job Aid - Avaya WLAN 8100 Series Reference

ACLI Reference for wired networks
Variable
[no]
[broadcast]
min-sec <min-sec>
mode {bootp | dhcp | bootp_dhcp}

Displaying the DHCP relay configuration for a VLAN

About this task
Use this procedure to display the current DHCP relay parameters configured for a VLAN.
Procedure
To display the DHCP relay VLAN parameters, enter the following from the Privileged
EXEC command mode:
show vlan dhcp-relay [<vid>]
Variable
[<vid>]
The following table shows the field descriptions for the show ip dhcp-relay command.
IfIndex
MIN_SEC
284 Avaya WLAN 8100 CLI Reference
Variable Definitions
Variable definitions
Specifies the VLAN ID of the VLAN to be displayed. Range is
1-4094.

Job aid

Field
Comments? infodev@avaya.com
Value
Disables DHCP relay on the specified VLAN.
Enables the broadcast of DHCP reply packets to
the DHCP clients on this VLAN interface.
The switch immediately forwards a BootP/DHCP
packet if the 'secs' field in the BootP/DHCP
packet header is greater than the configured min-
sec value; otherwise, the packet is dropped.
Range is 0-65535. The default is 0.
Specifies the type of DHCP packets this VLAN
supports:
• bootp - Supports BootP only
• dhcp - Supports DHCP only
• bootp_dhcp - Supports both BootP and DHCP
Value
Description
Indicates the VLAN interface index.
Indicates the minimum time, in seconds, to wait
between receiving a DHCP packet and forwarding the
DHCP packet to the destination device. A value of
August 2013