Avaya WLAN 8100 Series Reference page 181

Configuring Packet Storm Control Settings
About this task
Use the following procedure to configure Packet Storm Control settings.
Procedure
1. Enter Privileged mode of the CLI.
2. Enter Configuration mode by entering the config command.
3. Use the command storm-control and one of the following sub-commands to
CLI Help
About this task
To obtain help on the navigation and use of Command Line Interface (CLI), use the following
command: help {commands | modes}
Use help commands to obtain information about the commands available in CLI organized by
command mode. A short explanation of each command is also included.
Use help modes to obtain information about command modes available and CLI commands
used to access them.
These commands are available in any command mode.
Avaya WLAN 8100 CLI Reference
Packet Storm Control settings:
a. Use the enable sub-command to enable the feature.
b. Use the high-watermark <11–100000000> sub-command to set the high
watermark in packets per second.
c. Use the low-watermark <10–100000000> sub-command to set the low
watermark in packets per second.
d. Use the poll-interval <5–300> sub-command to set the poll interval in
seconds.
e. Use the trap-send-interval <0–1000> sub-command to set the trap send
interval in poll cycles.
ACLI reference for wired networks
August 2013 181