Avaya WLAN 8100 Series Reference page 297

Important:
To maximize your network performance, Avaya recommends that you set the router alert
option according to the version of IGMP currently in use: IGMPv1—Disable IGMPv2—
Enable IGMPv3—Enable
Procedure
To configure the router alert option on a VLAN, enter the following from the VLAN
Interface Configuration mode:
[default] [no] ip igmp router-alert
Variable
default
no
Displaying IGMP interface information
About this task
Use this procedure to display IGMP interface parameters.
Procedure
To display the IGMP interface information, enter:
show ip igmp interface vlan <Vlan ID>
OR
Enter:
show vlan igmp <Vlan ID>
Job aid
The following table shows the field descriptions for the show ip igmp interface
command.
VLAN
Query Intvl
Vers
Oper Vers
Avaya WLAN 8100 CLI Reference
Variable Definitions
Disables the router alert option.
Disables the router alert option.
Field
Indicates the VLAN on which IGMP is configured.
Specifies the frequency (in seconds) at which host query
packets are transmitted on the interface.
Specifies the version of IGMP configured on this
interface.
Specifies the version of IGMP running on this interface.
ACLI reference for wired networks
Value
Description
August 2013 297