Avaya WLAN 8100 Series Reference page 300

ACLI Reference for wired networks
The following table shows the field descriptions for the show vlan multicast
membership command.
Multicast Group Address
In Port
Configuring unknown multicast packet filter
About this task
The default switch behavior is to flood all packets with unknown multicast addresses. Use this
procedure to prevent the flooding of packets with unknown multicast addresses and enable
the forwarding of these packets to static mrouter ports only.
Procedure
To configure unknown multicast packet flooding, enter the following from the Global
Configuration mode:
[no] [default] vlan igmp <vid> unknown-mcast-no-flood {enable |
disable}
no
default
enable
disable
Displaying the status of unknown multicast packet filtering
About this task
Use this procedure to display the status of unknown multicast filtering: enabled (no flooding)
or disabled (flooding allowed).
Procedure
To display the unknown multicast flooding configuration, enter:
show vlan igmp unknown-mcast-no-flood
300 Avaya WLAN 8100 CLI Reference
Field
Variable Definitions
Variable
Enables the flooding of multicast packets on the VLAN.
Enables the flooding of multicast packets on the VLAN.
Prevents the flooding of multicast packets on the
VLAN.
Enables the flooding of multicast packets on the VLAN.
Comments? infodev@avaya.com
Description
Indicates the multicast group address.
Indicates the physical interface or a logical interface
(VLAN) that received group reports from various
sources.
Value
August 2013