Avaya WLAN 8100 Series Reference page 217

snmp-server user <username> [read-view<view-name>] [write-view<view-
name>] [notify-view<view-name]] md5|sha <password> [read-view<view-
name>] [write-view<view-name>] [notify-view<view-name]
The syntax for the snmp-server user command for authenticated and encrypted access
is:
snmp-server user <username> [read-view<view-name>] [write-view<view-
name>] [notify-view<view-name]] md5|sha <password> [read-view<view-
name>] [write-view<view-name>] [notify-view<view-name]] {3des|aes|
des} <password> [read-view<view-name>] [write-view<view-name>]
[notify-view<view-name]
The snmp-server user command is executed in the Global Configuration mode.
The sha and 3des/aes/des parameters are only available if the switch image has SSH
support.
For authenticated access, you must specify the md5 or sha parameter. For authenticated and
encrypted access, you must also specify the 3des, aes, or des parameter.
For each level of access, you can specify read, write, and notify views. If you do not specify
view parameters for authenticated access, the user will have access to the views specified for
unauthenticated access. If you do not specify view parameters for encrypted access, the user
will have access to the views specified for authenticated access or, if no authenticated views
were specified, the user will have access to the views specified for unauthenticated access.
The following table describes the parameters for this command.
Table 59: snmp-server user command parameters
Parameters
username
md5 <password>
read-view <view-name>
write-view <view-name>
Avaya WLAN 8100 CLI Reference
Description
Specifies the user name. Enter an alphanumeric string
of up to 255 characters.
Specifies the use of an md5 password. <password>
specifies the new user md5 password; enter an
alphanumeric string. If this parameter is omitted, the user
is created with only unauthenticated access rights.
Specifies the read view to which the new user has
access:
• view-name—specifies the viewname; enter an
alphanumeric string of up to 255 characters.
Specifies the write view to which the new user has
access:
• view-name—specifies the viewname; enter an
alphanumeric string that can contain at least some of
the nonalphanumeric characters.
ACLI reference for wired networks
August 2013 217