Avaya WLAN 8100 Series Reference page 282

ACLI Reference for wired networks
show ip dhcp-relay
Example
WCP8180#show ip dhcp-relay
DHCP relay is enabled
DHCP relay option82 is disabled
DHCP relay max-frame is 0
Specifying a local DHCP relay agent and remote DHCP server
About this task
Use this procedure to specify a VLAN as a DHCP relay agent on the forwarding path to a
remote DHCP server. The DHCP relay agent can forward DHCP client requests from the local
network to the DHCP server in the remote network.
The DHCP relay feature is enabled by default, and the default mode is BootP-DHCP.
Prerequisites
• Enable IP routing and configure an IP address on the VLAN to configure as a DHCP relay
agent.
Procedure
To configure a VLAN as a DHCP relay agent, enter the following from the Global
Configuration mode:
[no] ip dhcp-relay fwd-path <relay-agent-ip> <DHCP-server>
[enable] [disable] [mode {bootp | bootp-dhcp | dhcp}]
[no]
<relay-agent-ip>
<DHCP-server>
[enable]
[disable]
[mode {bootp | bootp-dhcp | dhcp}]
282 Avaya WLAN 8100 CLI Reference
Variable Definitions
Variable
Comments? infodev@avaya.com
Value
Removes the specified DHCP forwarding path.
Specifies the IP address of the VLAN that serves
as the local DHCP relay agent.
Specifies the address of the remote DHCP
server to which DHCP packets are to be
relayed.
Enables the specified DHCP relay forwarding
path.
Disables the specified DHCP relay forwarding
path.
Specifies the mode for DHCP relay.
August 2013