Avaya WLAN 8100 Series Reference page 25

Command
interface
no
observer-ip
observer-
port
profile-name
promisc-mode
Avaya WLAN 8100 CLI Reference
Parameters
include-control Include 802.11 control frames from captures on
radio interfaces. This filter is disabled by
default.
include-data Include 802.11 data in capture data. This filter
is enabled by default.
include-mgmt Include 802.11 management frames other than
probes/beacons in the capture data. This filter is
disabled by default.
include-probes Include 802.11 probe frames in capture data.
This filter is disabled by default.
ssid Traffic is captured only on specifies SSID. To
exclude filtering on SSID, set this value to empty
string. An empty string is also the default value.
This setting is ignored on promiscuous mode.
An AP checks the validity of the SSID when
packet capture is started.
a-radio Specifies 5.0 GHz radio interface only.
all Specifies all radio interfaces.
b-radio Specifies 2.4 GHz radio interface only.
Disables capture profile parameters.
ipaddr IP address of the observer host to which to send
the captured traffic.
<1–65535> Specifies the destination UDP port for sending
the captured traffic. This is the L4 port that
observer PC is listens on.
WORD<1–32> Specifies the name of the profile.
By default, a capture profile is created with the
profile name
Enable/Disable: When promiscuous mode is
disabled, only traffic directed to the AP is
captured. Note that enabling promiscuous
ACLI reference for the Wireless LAN (WLAN) 8100
Description
Important:
Ensure the observer host on the UDP port is
open. If you do not open the UDP port on the
observer host then the capture device
receives the ICMP port unreachable
error
for every capture packet in the
capture stream. This severely impacts
performance.
capture_profile_00n .
August 2013 25