Avaya WLAN 8100 Series Reference page 273

Procedure
To display the status of IP blocking on the switch, enter the following from the User
EXEC mode:
show ip routing
Configuring an IP address for a VLAN
About this task
To enable routing an a VLAN, you must first configure an IP address on the VLAN.
Procedure
To configure an IP address on a VLAN, enter the following from the VLAN Interface
Configuration mode:
[no] ip address <ipaddr> <mask> [<MAC-offset>]
[no]
<ipaddr>
<mask>
[<MAC-offset>]
Configuring IP routing status on a VLAN
About this task
Use this procedure to enable and disable routing for a particular VLAN.
Procedure
To configure the status of IP routing on a VLAN, enter the following from the VLAN
Interface Configuration mode:
[default] [no] ip routing
Avaya WLAN 8100 CLI Reference
Variable Definitions
Variable
ACLI reference for wired networks
Value
Removes the configured IP address and
disables routing on the VLAN.
Specifies the IP address to attach to the
VLAN.
Specifies the subnet mask to attach to the
VLAN
Specifies the value used to calculate the
VLAN MAC address, which is offset from the
switch MAC address. The valid range is
1-256. Specify the value 1 for the
Management VLAN only. If no MAC offset is
specified, the switch applies one
automatically.
August 2013 273