Avaya WLAN 8100 Series Reference page 303

Type
Flushing the router table
About this task
Use this procedure to flush the router table.
Procedure
To flush the router table, enter the following from the Global Configuration mode:
ip igmp flush vlan <vid> {grp-member|mrouter}
{grp-member|mrouter}
Configuring IGMP selective channel block
About this task
In certain deployment scenarios it might be required not to allow multicast streaming from
specific group addresses to users connected to certain ports. With the IGMP selective channel
block feature this type of control can be implemented. When configured it will control the IGMP
membership of ports by blocking IGMP reports received from users on that port destined for
the specific group address/addresses. The filter can be configured to block a single multicast
address or range of addresses.
This feature will work regardless of whether the switch is in Layer 2 IGMP snooping mode or
the full IGMP mode (PIM-SM enabled). It will also be applicable for IGMPv1 and v2.
Configuring IGMP selective channel block navigation
About this task
• Creating an IGMP profile
• Deleting an IGMP profile
• Applying the IGMP filter profile on interface
• Removing a profile from an interface
• Displaying an IGMP profile
Avaya WLAN 8100 CLI Reference
Field
Variable Definitions
Variable
on page 304
on page 304
on page 305
Description
hearing an IGMPv1 membership report, this value
is reset to the group membership timer.
When the time remaining is nonzero, the local
interface ignores IGMPv2 leave messages that it
receives for this group.
Indicates whether the entry is learned dynamically
or is added statically.
Flushes the table specified by type.
on page 304
on page 304
ACLI reference for wired networks
Value
August 2013 303