Avaya WLAN 8100 Series Reference page 312

ACLI Reference for wired networks
Removing IP classifier entries
About this task
Use the following procedure to remove IP classifier entries.
Note: An IP element that is referenced in a classifier cannot be deleted.
Procedure
Remove IP classifier entries by using the following command from Global
Configuration mode.
no qos ip-element <1-55000>
Adding Layer 2 elements
About this task
Use the following procedure to add Layer 2 elements.
Note: A Layer 2 element referenced in a classifier cannot be deleted.
Procedure
Add Layer 2 elements by using the following command from the Global Configuration
mode.
qos l2-element <1-55000> [dst-mac <dst-mac>] [dst-mac-mask
<dst-mac-mask>] [ethertype <etype>] [ivlan-min <vid-min>] [pkt-
type <etherII | llc | snap>] [priority <ieee1p-seq>] [session-
id <session-id>] [src-mac <src-mac>] [src-mac-mask <src-mac-
mask>] [vlan-min <vid-min>] [vlan-tag <vtag>]
Variable Definitions
<1-55000>
dst-mac <dst-mac>
dst-mac-mask <dst-mac-mask>
ethertype <etype>
312 Avaya WLAN 8100 CLI Reference
Variable
Comments? infodev@avaya.com
Value
Specifies the element ID; range is 1–55000.
Specifies the destination MAC element criteria.
Valid format is H.H.H.
Specifies the destination MAC mask element
criteria. Valid format is H.H.H.
Specifies the Ethernet type. Valid format is
0xXXXX, for example, 0x0801. Default is
ignore.
August 2013