Avaya WLAN 8100 Series Reference page 225

<level>
none
Viewing TACACS+ information
About this task
To display TACACS+ configuration status, enter the following command from any mode:
show tacacs
Configuring IP Manager using CLI
About this task
To configure the IP Manager to control management access to the switch, do the following:
• Enable IP Manager.
• Configure the IP Manager list.
Use the following commands to configure the IP Manager.
Related topics:
Enabling IP Manager
Configuring the IP Manager list
Removing IP Manager list entries
Viewing IP Manager settings
Enabling IP Manager
About this task
To enable IP Manager to control Telnet, SNMP, SSH, or HTTP access, use the following
command in Global Configuration mode:
ipmgr {telnet|snmp|web|ssh}
The following table describes the parameters for this command.
Avaya WLAN 8100 CLI Reference
Parameter
on page 225
on page 226
on page 227
Description
An integer in the range 0–15 that specifies the
privilege levels for which authorization is enabled.
You can enter a single level, a range of levels, or
several levels. For any levels you do not specify,
authorization does not apply, and users assigned
to these levels can execute all commands.
Authorization is not enabled for any privilege level.
All users can execute any command available on
the switch.
on page 226
ACLI reference for wired networks
August 2013 225