Avaya WLAN 8100 Series Reference page 158

ACLI Reference for wired networks
The default flowcontrol command is used only on Gigabit Ethernet ports and sets the
flow control to auto, which automatically detects the flow control.
The syntax for the default flowcontrol command is: default flowcontrol [port
<portlist>]
The default flowcontrol command is executed in the Interface Configuration mode.
The following table describes the parameters for this command.
Parameters
port <portlist>
The default rate-limit command restores the rate-limiting value for the specified port
to the default setting.
The syntax for the default rate-limit command is: default rate-limit [port
<portlist>]
The default rate-limit command is executed in the Interface Configuration command
mode.
The following table describes the parameters for this command.
Table 12: default rate-limit command parameters
Parameters
port <portlist>
Enabling rate-limiting
About this task
The percentage or packets per seconds of multicast traffic, broadcast traffic, or both, can be
limited using the CLI.
158 Avaya WLAN 8100 CLI Reference
Parameters
default flowcontrol command
Specifies the port numbers to default to auto flow
control.
Note: If you omit this parameter, the system uses the port
number you specified in the
default rate-limit command
Specifies the port numbers on which to reset rate-limiting to
factory default. Enter the port numbers on which to set rate-
limiting to default.
Note: If you omit this parameter, the system uses the port
number you specified in the interface command.
Comments? infodev@avaya.com
Description
interface command, but only those ports
that have speed set to 1000/full.
Description
interface
Description
command.
August 2013