Avaya WLAN 8100 Series Installation Manual
Hide thumbs
Also See for WLAN 8100 Series:
- Reference (382 pages) ,
- Regulatory information (160 pages) ,
- Quick start manual (119 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Avaya WLAN 8100 Series
Summary of Contents for Avaya WLAN 8100 Series
- Page 1 Avaya WLAN 8100 Installation–AP 8120 1.0.0.0 NN47251-302, 01.01 August 20, 2010...
- Page 2 Avaya or the applicable third party. Avaya does not guarantee that these links will work all the time and has no control over the availability of the linked pages.
-
Page 3: Table Of Contents
Mounting a wireless LAN access point on a wall....................13 Installing an Access Point with a ceiling grid adaptor..................15 Chapter 4: Installation tools and utilities................19 Installation hardware and tools........................19 Chapter 5: Access Point Troubleshooting................21 Appendix A: Appendix......................23 IEEE 802.11a/b/g Channel Designations:.......................23 Avaya WLAN 8100 Installation–AP 8120 August 20, 2010... - Page 4 Avaya WLAN 8100 Installation–AP 8120 August 20, 2010...
-
Page 5: Chapter 1: Installation Reference
Chapter 1: Installation reference Access Point 8120 overview The Avaya Access Point 8120 (AP 8120) is the wireless access portion of the Avaya WLAN 8100 Series solution. The AP 8120 provides 802.11a+n b/g+n wireless connectivity through six dual-band 2.4/5.0 GHz antennas; three dedicated to 2.4 GHz use and three dedicated to 5.0 GHz . - Page 6 Installation reference Access Point 8120 rear view The following diagram illustrates the rear view of the Access Point 8120. Avaya WLAN 8100 Installation–AP 8120 August 20, 2010...
- Page 7 The AP 8120 has four LEDs that provide status information on the device. Refer to Access Point 8120 front view on page 5 for the location of the LEDs. The following table describes the different states of the LEDs. Avaya WLAN 8100 Installation–AP 8120 August 20, 2010...
- Page 8 The access point is connected to a 10M PoE port. Unlit The access point does not have network connectivity. AP Power Solid green The access point is receiving power. Unlit The access point is not receiving power. Avaya WLAN 8100 Installation–AP 8120 August 20, 2010...
-
Page 9: Chapter 2: Installation Preparation
RJ-45 connectors to connect to a network device. The AP 8120 supports 802.3af. An Avaya-approved power injectors must be used to provide the access point with power over the Ethernet cable. The WC 8180 has no PoE capabilities. -
Page 10: Management Software
AP. The following table lists the pin signals for the 10/100/1000 Ethernet straight-through wiring. Pins 4, 5, 7, and 8 are used when Avaya Power over Ethernet (PoE) is enabled on the port. Wireless Controller 8180... -
Page 11: Network Plans And Work Orders
• settings for all APs in the WLAN For information about installing WLAN Management Software , creating and verifying a network plan, and generating an AP work order, see the Avaya WLAN 8100 - Planning and Engineering document. Wireless Controller 8180 recommendation Avaya recommends that you install and configure the Wireless Controller 8180 before installing an AP. -
Page 12: Radio Frequency Advisories
Federal Communications Commission (FCC) Docket 96-8 for Spread Spectrum Transmitters specifies a safety standard for human exposure to radio frequency electromagnetic energy emitted by FCC-certified equipment. The Avaya Access Point 8120 product meets the uncontrolled environmental limits found in OET-65 and ANSI C95.1-1991, if proper installation procedures are followed. -
Page 13: Chapter 3: Access Point 8120 Installation
2mm gap between the screw head and the wall. 3. Slip the wall bracket over the heads of the screws and slide the bracket to the right as viewed facing the wall. Avaya WLAN 8100 Installation–AP 8120 August 20, 2010... - Page 14 4. Tighten the screws to secure the wall mounting bracket tightly against the wall. 5. Align the mounting tabs on the bottom of the access point sheet metal enclosure with the vertically oriented keyhole slots in the mounting bracket. Avaya WLAN 8100 Installation–AP 8120 August 20, 2010...
-
Page 15: Installing An Access Point With A Ceiling Grid Adaptor
Perform the following procedure to install the access point with a ceiling grid adaptor: Avaya WLAN 8100 Installation–AP 8120 August 20, 2010... - Page 16 Use a screwdriver to screw down the captive fastener. Securing the two brackets in this manner is essential to prevent them from disengaging from one another. Tighten the captive fastener screw securely. Avaya WLAN 8100 Installation–AP 8120 August 20, 2010...
- Page 17 If the access point and the bracket assembly are correctly engaged, it should be possible to engage the access points captive thumbscrew into the threaded tab provided on the ceiling grid bracket. Avaya WLAN 8100 Installation–AP 8120 August 20, 2010...
- Page 18 Access Point 8120 installation 6. Make electrical connections and return ceiling tiles. Avaya WLAN 8100 Installation–AP 8120 August 20, 2010...
-
Page 19: Chapter 4: Installation Tools And Utilities
Included with the product tools Ceiling installations Universal mounting bracket T-bar clamp Box cutter Small screwdriver (3-mm or 1/8-inch) Junction box Wall mounting Universal mounting bracket Small screwdriver (3-mm or 1/8-inch) #2 Phillips-head screwdriver No Avaya WLAN 8100 Installation–AP 8120 August 20, 2010... - Page 20 Installation tools and utilities Avaya WLAN 8100 Installation–AP 8120 August 20, 2010...
-
Page 21: Chapter 5: Access Point Troubleshooting
A configuration sync was just from blinking green to blue to executed. unlit (for a few seconds) and then back to blinking green and blue Power LED is red. The AP was just reset. Avaya WLAN 8100 Installation–AP 8120 August 20, 2010... - Page 22 Access Point Troubleshooting Avaya WLAN 8100 Installation–AP 8120 August 20, 2010...
-
Page 23: Appendix A: Appendix
Frequency (GHz) 5.180 5.200 5.220 5.240 5.260 5.280 5.300 5.320 5.470 to 5.725 GHz bands IEEE mode Channel Number Frequency (GHz) 5.500 5.520 5.540 5.560 5.580 5.600 5.620 5.640 IEEE mode Channel number Avaya WLAN 8100 Installation–AP 8120 August 20, 2010... - Page 24 • All combinations, such as 1, 2, 7 represent all of the channels listed in the separate sections of 1, 2 and 7: 36, 40, 44, 48, 52, 56, 60, 64, 149, 153, 157, 161, 165 Avaya WLAN 8100 Installation–AP 8120 August 20, 2010...
Need help?
Do you have a question about the WLAN 8100 Series and is the answer not in the manual?
Questions and answers