Avaya WLAN 8100 Series Reference page 155

Note:
The accuracy margin of cable length diagnosis is between three to five meters. Avaya
suggests the shortest cable for length information be five meters long.
Use the following CLI commands to initiate a TDR cable diagnostic test and obtain test
reports.
Related topics:
tdr test command
show tdr command
The tdr test command initiates a TDR test on a port or ports.
The syntax for this command is: tdr test <portlist>
where <portlist> specifies the ports to be tested.
The tdr test command is in the privExec command mode.
The show tdr command displays the results of a TDR test.
The syntax for this command is: show tdr <portlist>
where <portlist> specifies the ports for which to display the test results.
The show tdr command is in the privExec command mode.
Enabling Autotopology
About this task
The Optivity Autotopology protocol can be configured using the CLI.
Use the following commands to enable autotopology using the CLI.
Related topics:
autotopology command
no autotopology command
default autotopology command
show autotopology settings command
show autotopology nmm-table command
The autotopology command enables the Autotopology protocol.
The syntax for the autotopology command is: autotopology
The autotopology command is executed in the Global Configuration command mode.
Avaya WLAN 8100 CLI Reference
on page 155
on page 155
tdr test command
show tdr command
on page 155
on page 156
autotopology command
on page 156
on page 156
on page 156
ACLI reference for wired networks
August 2013 155