Avaya WLAN 8100 Series Reference page 341

no qos policy <1-55000>
QoS Generic Filter set configuration
Use the following procedures to configure and manipulate a generic filter set.
Related topics:
Configuring a traffic profile set
Deleting a classifier, classifier block, or an entire filter set
Viewing filter descriptions
Configuring a traffic profile set
About this task
Configure a traffic profile set by performing the following procedure.
Procedure
Use the following command to configure a traffic profile classifier entry.
qos traffic-profile set port <port> name <name> [commited-rate
<64-10230000>] [drop-nm-action <drop | pass>] [enable]
This command is used in the Global Configuration mode.
port <port>
name <name>
commited-rate <64-10230000>
drop-nm-action <drop | pass>
enable
Deleting a classifier, classifier block, or an entire filter set
About this task
Delete a filter classifier or set by performing this procedure.
Avaya WLAN 8100 CLI Reference
on page 341
on page 342
Variable Definitions
Variable
ACLI reference for wired networks
on page 341
Value
Specifies the ports to apply the traffic profile
to.
Specifies the name of the traffic profile.
Specifies the committed rate in Kilobits per
second.
Specifies the action to take when the packet
is nonmatching. This action is applied to all
traffic that was not previously matched by the
specified filtering data. Options are
(packet is dropped) and
dropped).
Enables the traffic profile.
drop
pass (packet is not
August 2013 341