Avaya WLAN 8100 Series Reference page 200

ACLI Reference for wired networks
The syntax for the mac-security command for specific ports is
mac-security [port <portlist>] {disable|enable|learning}
The following table outlines the parameters for this command.
Table 46: mac-security parameters
port <portlist>
disable|enable|learning
The mac-security command for specific ports executes in the Interface Configuration
mode.
show mac-security command
The show mac-security command displays the current MAC Address security table for the
ports entered. The syntax for this command is
show mac-security port <portlist>
Substitute <portlist> with the ports to be displayed.
This command executes in the Privileged EXEC command mode.
mac-security mac-da-filter command
The mac-security mac-da-filter command allows packets to be filtered from up to ten
specified MAC DAs. This command also allows you to delete such a filter and then receive
packets from the specified MAC DA.
The syntax for the mac-security mac-da-filter command is
mac-security mac-da-filter {add|delete} <H.H.H>
Substitute the {add|delete} <H.H.H> with either the command to add or delete a MAC
address and the MAC address in the form of H.H.H.
200 Avaya WLAN 8100 CLI Reference
Parameter
Comments? infodev@avaya.com
Description
Enter the port numbers.
Directs the specific port
• disable—disables BaySecure on the specified
port and removes the port from the list of ports
for which MAC address learning is being
performed
• enable—enables BaySecure on the specified
port and removes the port from the list of ports
for which MAC address learning is being
performed
• learning—disables BaySecure on the specified
port and adds these port to the list of ports for
which MAC address learning is being performed
August 2013