Resetting Spanning Tree Values For Ports To Default - Avaya WLAN 8100 Series Reference

Use the no form of this command to disable.
Variable Definitions
port <portlist>
stp <1-8>
learning {disable|normal|fast}
cost <1-65535>
priority
About this task
Use the following procedure to set the spanning tree values for the ports within the specified
Spanning Tree Group to the factory default settings.
Procedure
To reset Spanning Tree values to default, use the following command from Interface
Configuration mode.
default spanning-tree [port <portlist>] [stp <1-8>] [learning]
[cost] [priority]
Avaya WLAN 8100 CLI Reference
Variable

Resetting Spanning Tree values for ports to default

ACLI reference for wired networks
Value
Enables the spanning tree for the specified
port or ports; enter port or ports you want
enabled for the spanning tree.
Note: If you omit this parameter, the system
uses the port number you specified when you
issued the interface command to enter the
Interface Configuration mode.
Specifies the spanning tree group; enter the
STG ID.
Specifies the STP learning mode:
• disable -- disables FastLearn mode
• normal -- changes to normal learning mode
• fast -- enables FastLearn mode
Enter the path cost of the spanning tree;
range is 1 -- 65535.
Sets the spanning tree priority for a port as a
hexadecimal value. If the Spanning Tree
Group is 802.1T compliant, this value must
be a multiple of 0x10.
August 2013 255