Keysight Technologies N9030B Service Manual page 518

Assembly Replacement Procedures
Disk Drive
5. Remove the disk drive (2) from the carrier assembly.
6. Place the new disk drive onto the carrier assembly and attach with the 4
7. Refer to
8. Locate the Windows License Sticker from the kit and apply the sticker to
Figure 16-82 Windows License Sticker Rear Panel Location
9. Refer to
518
machine screws (1) (0515-0372). Torque to 9 in-pounds.
Figure 16-80. Replace the disk drive carrier assembly (2) into the
instrument and tighten the screw to 9 in-pounds.
the rear of the instrument as shown in
license sticker.
Chapter 17, "Post-Repair Procedures."
specified tasks for replacing the A5 Disk Drive assembly.
Figure 16-82, covering the existing
and perform all of the
N9030B PXA Signal Analyzer Service Guide