Keysight Technologies N9030B Service Manual page 384

Replaceable Parts
Replaceable Parts
Table 15-1 All Replaceable Parts
Reference
Description
Designator
EMI O-Ring 18.75 mm ID
Used between RF input connector and front frame
J2 EXT MIXER Connector (discard washer and nut, if supplied)
AT1 Attenuator, 6dB, coax, (8493C) connects to SW 2 and W13
(Option MPB)
SW1 Switch, Coax, used for Preselector Bypass
(Options 503, 508, 513, 526 with Option MPB)
SW2 Switch, Coax, used for Preselector Bypass
(Options 503, 508, 513, 526 with Option MPB)
SW3 Switch, Transfer, used for Low Noise Path
(Options 503, 508, 513, 526 with Option LNP)
Switch, Transfer, used for Low Noise Path
(Options 544, 550 with Option LNP)
SW4 Switch, Transfer, used for Microwave Preselector Bypass
(Options 544, 550 with Options MPB)
SW5 Switch, Coax, on Option B5X Front End Assembly
SW6 Switch, Coax, on Option B5X Front End Assembly
50 ohm Termination, SMA male used on A13 J8
Chassis Base
Gusset, Chassis (near RF input connector)
Chassis Side, Left (inner)
Chassis Side, Right (inner)
Card Guide (for chassis left and right)
Clamp, Ribbon Cable (attaches to right front chassis side)
Cable Clamp for coax cables (attaches to right rear chassis side)
Rear Frame
Bracket, Midplane
Bracket, Chassis Front
Bracket, Fan
Bracket, RF Side (right side outer)
384 N9030B PXA Signal Analyzer Service Guide
Part Number
8160-1637
1250-1666
08493-60026
N1810-60069
N1810-60069
87222-60026
87222-60029
87222-60031
N1810-60102
N1810-60102
1810-0118
N9020-00015
W1312-00093
W1312-00117
W1312-00116
W1312-40001
5023-1397
5023-1379
N9020-00065
W1312-00048
W1312-00098
W1312-00118
N9020-00014