Keysight Technologies N9030B Service Manual page 412

Replaceable Parts
Hardware
Figure 15-13 Front End Cables (A14 Synthesizer shown is Option EP1)
Table 15-15
Item Description
1 A15 Front End Controller
2 A14 Synthesizer Assembly, Standard (Option EP1)
W5 Cable, Ribbon, Attenuator A/B to Front End Controller J800
W7 Cable, ribbon, Lowband Switch J4 to Front End Controller J700
W11 Cable, wire harness, YTF Control, Front End Controller J300 to
YTF J1
W12 Cable, wire harness, Preselector bypass switch control, FE
controller J801 (Option LNP / MPB, no B5X)
W16 Cable, IF Out from Front End Assy J7 to Front End Control J902
W21 Cable, semi-rigid, LO Synthesizer Assy J20 to Front End Assy J5
(without EP0)
W25 Cable, coax, Narrow Band IF Out, Front End Controller J900 to
Analog IF J100
W26 Cable, coax, Wideband IF Out, Front End Controller J901 to
Digital IF J15 (instruments without Option B1X, B2X, B5X)
W27 Cable, coax, Aux IF Out, Front End Controller J1100 to rear panel
Aux IF Out
W28 Cable, ribbon, Switched Filter control, Front End Controller J1300
to Switched Filter J1
412
Front End Cables
Keysight Part Number
Option dependent
refer to Table 15-1
N9020-60008
E4410-60157
N9020-60092
N9020-60059
E4410-60159
8121-1862
N9020-20019
8121-1865
8121-1919
8121-1859
N9020-60064
N9030B PXA Signal Analyzer Service Guide