Keysight Technologies N9030B Service Manual page 136

Instrument Messages
Condition Messages
Err# Bit in
Status
Register
217 7
217 7
217 7
217 7
219 8
221 9
221 9
221 9
223 10
225 11
227 12
229 13
231 14
136
Message
Demod Error;Not an
active slot
Demod Error;No full
subframe found
Demod Error;Muxed
bits not found
Demod Error;Acq Time
too short
Signal Too Noisy
Slot Error
Slot error;No active
slot found
Slot Error; No idle
slot found
unused
unused
unused
unused
unused
Error or More Information
Warning
E There is no active slot detected.
E No sub-frame or only part of one sub-frame is
detected.
E Multiplexed Data Demod Bits are not
generated even though Data channel is
selected, because all 16 data code channels
are not active
E For Bluetooth, the detected packet type
doesn't match the captured packet type
because the payload start, end or data could
not be found.
E NADC & PDC: The valid EVM measurement
cannot be performed, because the input signal
is too noisy.
GSM & EDGE: In a GSM measurement,
indicates that a burst could not be found in a
signal that appears noisy.
In the PSA, this error was reported as one of
the following error numbers: 10702, 10824,
10906, 10930, 13024, 10626, 111
E
E No valid active slot found in captured data, or
no active slot found in captured interval.
Synchronization may succeed and pilot found
when this message is issued, but no results are
included in peak/average calculation.
E No valid idle slot found in captured data, or no
idle slot found in captured interval.
Synchronization may succeed and pilot found
when this message is issued, but no results are
included in peak/average calculation.
E
E
E
E
E
N9030B PXA Signal Analyzer Service Guide