Keysight Technologies N9030B Service Manual page 134

Instrument Messages
Condition Messages
Err# Bit in
Status
Register
209 3
209 3
211 4
213 5
213 5
213 5
215 6
215 6
215 6
215 6
215 6
215 6
134
Message
Timing Error
Timing Error:No time
ref pilot burst
Carrier(s) incorrect
or missing
Freq Out of Range
Freq Out of Range;
System input (IF)
Freq Out of Range;
External LO
Sync Error
Sync Error;No pilot
burst
Sync Error;Sync code
not found
Sync Error;No freq
ref pilot burst
Sync Error;Midamble
sync fail
Sync Error;Preamble
length zero
Error or More Information
Warning
E
E The pilot burst used for time reference is not
active.
E In the PSA, this error was reported as one of
the following error numbers: 10165, 10173,
10178, 10419, 10421, 10535, 10560, 10642,
10648, 10650, 10960
E
E One or more system input frequencies are out
of range. If using a frequency list, check that all
entries are valid for current measurement
mode.
E One or more external LO frequencies are out of
range. Check that the LO frequency limits are
set correctly and check the entered
measurement frequencies and measurement
mode.
E W-CDMA: Cannot sync DPCCH pilot.
Cannot synchronize measurement with DPCCH
pilot for Power Control measurement, because
the pilot signal cannot be found. Make sure
DPCCH is present in the W-CDMA uplink
signal, and that the slot format and scramble
code are set correctly.
E There is no Pilot burst detected.
E Synchronization code is not found in the
measured time slot.
E The pilot burst used for frequency reference is
not active.
E Failed to find the uplink slot, which caused the
synchronization with the midamble to fail.
E Burst type is "Data" or "Preamble" and the
measurement cannot find a Preamble
N9030B PXA Signal Analyzer Service Guide