Keysight Technologies N9030B Service Manual page 139

Instrument Messages
Condition Messages
Err# Status
Register
Bit
309 4
309 4
309 4
311 5
311 5
311 5
313 6
313 6
315 7
317 8
319 9
321 10
323 11
325 12
327 13
N9030B PXA Signal Analyzer Service Guide
Message
User Cal; Freq outside cal
range
User Cal; Cal will be
interpolated
User Cal; Adjusted for new
RBW
Calibration
Calibration; ENR table
extrapolated
Calibration; No ENR data
present
Source Uncal
Source Uncal;adj Start Freq
or RBW
unused
unused
unused
unused
unused
unused
unused
Error or Verbose/Correction Information
Warning
E The existing user cal has been invalidated
because the current measurement
frequencies lie partially or wholly outside
the range of frequencies used for
user-cal. (UNCAL)
W The measurement frequency range has
been changed such that it is a subset of
the calibrated range. (~CAL)
W The measurement RBW has been
changed since the last calibration (~CAL)
W
W One or more calibration or measurement
frequency points exceed the currently
loaded Cal or Meas ENR Table frequency
ranges. The corresponding ENR table's
lowest frequency ENR value will be
re-used for frequencies less than the
table range, and the highest frequency
ENR value will be re-used for frequencies
greater than the table range.
(~ENR)
W No ENR Data (ENR)
W
W While using a Tracking Source, you must
make sure the Start Frequency is high
enough to avoid capturing LO
feedthrough in the trace. This depends
on both Start Freq and RBW. If you get
this message, increase your Start Freq or
narrow your RBW.
W
W
W
W
W
W
W
139