Mitsubishi Electric R60AD8-G User Manual page 196

CH1 Loading interrupt enable/disable setting
Set whether to enable or disable the logging read function.
For details on the logging function, refer to the following.
Page 61 Logging Function
Setting value
0
1
• If a value other than the above is set, a read interrupt enable/disable setting range error (error code: 1D8H) occurs.
Logging cannot be performed.
• When CH1 Logging read enable/disable setting (Un\G544) is set to Enable (0), an interrupt is generated and sent to the
CPU module by setting a read pointer each time an amount equivalent to the logging read points setting value is logged.
■Buffer memory address
The following shows the buffer memory address of this area.
• CH Loading interrupt enable/disable setting
CH1 CH2 CH3
544 744 944
• CH Loading interrupt enable/disable setting (in Q compatible mode)
CH1 CH2 CH3
1200 1201 1202
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is Disable (1) for all channels.
The interrupt pointer to be used is preset but can be changed. To change the interrupt pointer, set the
corresponding interrupt pointer with the engineering tool.
APPX
194
Appendix 3 Buffer Memory Areas
CH4 CH5 CH6 CH7
1144 1344 1544 1744
CH4 CH5 CH6 CH7
1203 1204 1205 1206
Setting content
Enable
Disable
CH8 CH9 CH10 CH11
1944 2144 2344 2544
CH8 CH9 CH10 CH11

1207
CH12 CH13 CH14 CH15
2744 2944 3144 3344
CH12 CH13 CH14 CH15
CH16
3544
CH16