Mitsubishi Electric R60AD8-G User Manual page 179

CH1 Alert output setting (Rate alarm)
Set whether to enable or disable the alert output of the rate alarm.
For details on the alert output function, refer to the following.
Page 30 Alert Output Function
Setting value
0
1
If a value other than the above is set, an alert output setting (Rate alarm) range error (error code: 1B8H) occurs.
■Buffer memory address
The following shows the buffer memory address of this area.
• CH Alert output setting (Rate alarm)
CH1 CH2 CH3 CH4
513 713 913 1113
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is Disable (1) for all channels.
Alert output setting [Q compatible mode]
When the Q compatible mode function is used, set whether to enable or disable the alert output of process alarms and rate
alarms.
b15 b14 b13 b12 b11 b10 b9
CH8 CH7 CH6 CH5 CH4 CH3 CH2
(2)
(1) 0: Process alarm enabled, 1: Process alarm disabled
(2) 0: Rate alarm enabled, 1: Rate alarm disabled
■Buffer memory address
The following shows the buffer memory address of this area.
Only the R60AD8-G can use this area.
Buffer memory name
Alert output setting (Process alarm)/Alert output
setting (Rate alarm)
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
• b0 to b7: The default value is Process alarm disabled (1).
• b8 to b15: The default value is Rate alarm disabled (1).
CH5 CH6 CH7 CH8
1313 1513 1713 1913
b8 b7 b6 b5 b4 b3 b2
CH1 CH8 CH7 CH6 CH5 CH4 CH3
(1)
CH1 CH2
48
Setting content
Enable
Disable
CH9 CH10 CH11
2113 2313 2513
b1 b0
CH2 CH1
CH3 CH4 CH5
CH12 CH13 CH14 CH15
2713 2913 3113 3313
CH6 CH7
APPX
Appendix 3 Buffer Memory Areas
CH16
3513
A
CH8
177