Mitsubishi Electric R60AD8-G User Manual page 189

CH1 Input signal error detection upper limit set value [Q compatible mode]
In the Q compatible mode, set an upper limit value to detect an input signal error.
The operation varies depending on the value set in 'CH1 Input signal error detection extension/input signal error detection
setting' (Un\G47).
• When Upper limit value/lower limit value same (0) is set
The value set in this area is ignored.
• When Upper limit value/lower limit value different (1) is set
Set an upper limit value to detect an input signal error.
■Buffer memory address
The following shows the buffer memory address of this area.
Only the R60AD8-G can use this area.
Buffer memory name
CH Input signal error detection upper limit set
value (in Q compatible mode)
■Setting range
The setting range is from 0 to 250 (0 to 25.0%). Set it in a unit of 1 (0.1%).
In the channel where a value out of the above range is set, an input signal error detection setting value range error (error
code: 1C1H) occurs.
However, setting 251 disables the input signal error detection.
For the setting method, refer to the following.
Page 185 CH1 Input signal error detection setting value/lower limit set value [Q compatible mode]
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is 50 for all channels.
CH1 Logging enable/disable setting
Set whether to enable or disable the logging function.
For details on the logging function, refer to the following.
Page 61 Logging Function
Setting value
0
1
If a value other than the above is set, a logging enable/disable setting range error (error code: 1D0H) occurs.
■Buffer memory address
The following shows the buffer memory address of this area.
• CH Logging enable/disable setting
CH1 CH2 CH3 CH4
535 735 935 1135
• CH Logging enable/disable setting (in Q compatible mode)
CH1 CH2 CH3 CH4
1000 1001 1002 1003
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is Disable (1) for all channels.
CH1 CH2
150 151
CH5 CH6 CH7 CH8
1335 1535 1735 1935
CH5 CH6 CH7 CH8
1004 1005 1006 1007
CH3 CH4 CH5
152 153 154
Setting content
Enable
Disable
CH9 CH10 CH11 CH12
2135 2335 2535 2735
CH9 CH10 CH11 CH12

Appendix 3 Buffer Memory Areas
CH6 CH7 CH8
155 156 157
CH13 CH14 CH15 CH16
2935 3135 3335 3535
CH13 CH14 CH15 CH16
APPX
A
187