Precautions for channel number and output signal
Before wiring for SIL2 mode, pay attention to the following points.
Precautions for channel number
All the channels used for the R60AD8-G (Main), R60AD8-G (Sub), and R60DA8-G for diagnostics should use the same
channel number.
Ex.
When the R60AD8-G (Main) and R60AD8-G (Sub) use CH1 to make A/D conversion, the R60DA8-G for diagnostics must use
CH1.
Precautions for output signal
When a relay is wired with the RY40PT5B, the output signals used for the RY40PT5B should be wired as follows.
Output signals used
for the RY40PT5B
R60AD8-G (Main) side
R60AD8-G (Sub) side
Ex.
When the R60AD8-G (Main) and R60AD8-G (Sub) use CH1, wire the R60AD8-G (Main) to Y0 of the RY40PT5B and wire the
R60AD8-G (Sub) to Y1 of the RY40PT5B.
9 INSTALLATION AND WIRING
248
9.2 External Wiring
Channel used by the R60AD8-G
CH1
CH2
Y0
Y2
Y1
Y3
CH3
CH4
Y4
Y6
Y5
Y7
CH5
CH6
Y8
YA
Y9
YB
CH7
CH8
YC
YE
YD
YF