Mitsubishi Electric R60AD8-G User Manual page 172

A/D conversion enable/disable setting [Q compatible mode]
When the Q compatible mode function is used, set whether to enable or disable the A/D conversion.
b15 b14 b13 b12 b11 b10 b9
CH8 CH7 CH6 CH5 CH4
(2)
(1) 0: A/D conversion enabled, 1: A/D conversion disabled
(2) b8 to b15 are fixed to 0.
■Buffer memory address
The following shows the buffer memory address of this area.
Only the R60AD8-G can use this area.
Buffer memory name
A/D conversion enable/disable setting (in Q
compatible mode)
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is A/D conversion disabled (1).
CH1 Averaging process specification
Select processing to be performed among the sampling processing, averaging processing, and filter processing.
Averaging processing consists of time average, count average, and moving average.
Setting value
0
1
2
3
4
If a value other than the above is set, an averaging process specification setting range error (error code: 191H) occurs.
■Buffer memory address
The following shows the buffer memory address of this area.
• CH Averaging process specification
CH1 CH2 CH3
501 701 901
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
The default value is Sampling processing (0) for all channels.
APPX
170
Appendix 3 Buffer Memory Areas
b8 b7 b6 b5 b4
CH3 CH2 CH1 CH8 CH7 CH6 CH5
CH1
0
CH4 CH5 CH6
1101 1301 1501
b3 b2 b1 b0
CH4 CH3 CH2 CH1
(1)
CH2 CH3 CH4
Setting content
Sampling processing
Time average
Count average
Moving average
Primary delay filter
CH7 CH8 CH9 CH10
1701 1901 2101 2301
CH5 CH6
CH11 CH12 CH13 CH14
2501 2701 2901 3101
CH7 CH8
CH15 CH16
3301 3501