Mitsubishi Electric R60AD8-G User Manual page 185

■Default value
The default value is Disable (0) for all channels.
Input signal error detection extension setting/setting [Q compatible mode]
When the Q compatible mode function is used, set a condition for detecting an input signal error.
Input signal error detection extension/
input signal error detection setting
(Un\G47)
• When Upper limit value/lower limit value same (0) is set
The input signal error detection upper limit value and the input signal error detection lower limit value are calculated by using
CH1 Input signal error detection setting value/CH1 Input signal error detection lower limit set value (Un\G142). In that case,
CH1 Input signal error detection upper limit set value (Un\G150) is ignored.
• When Upper limit value/lower limit value different (1) is set
The input signal error detection upper limit value is calculated by using CH1 Input signal error detection upper limit set value
(Un\G150).
The input signal error detection lower limit value is calculated by using CH1 Input signal error detection setting value/CH1
Input signal error detection lower limit set value (Un\G142).
■Buffer memory address
The following shows the buffer memory address of this area.
Only the R60AD8-G can use this area.
Buffer memory name
Input signal error detection extension/input signal error
detection setting (in Q compatible mode)
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9).
■Default value
• b0 to b7: The default value is Disabled (1).
• b8 to b15: The default value is Upper limit value/lower limit value same (0).
b15 b14 b13 b12 b11 b10 b9
CH8 CH7 CH6 CH5 CH4 CH3 CH2 CH1
0: Upper limit value/lower limit value same
1: Upper limit value/lower limit value different
CH1 CH2
47
b8 b7 b6 b5 b4 b3 b2
CH8 CH7 CH6 CH5 CH4 CH3
0: Enabled
1: Disabled
CH3 CH4 CH5
b1 b0
CH2 CH1
CH6 CH7 CH8
APPX
Appendix 3 Buffer Memory Areas
A
183