Mitsubishi Electric R60AD8-G User Manual page 121

Offset/gain setting mode status flag
■Device number
The following shows the device number of this input signal.
Signal name
Offset/gain setting mode status flag
■In the offset/gain setting mode
When registering the value, which has been adjusted with the offset/gain setting, use Offset/gain setting mode status flag (XA)
as an interlock condition to turn on and off 'User range write request' (YA).
When the offset/gain setting is configured from the offset/gain setting window of an engineering tool, the setting is performed
properly on the window. Therefore, a program is not required to perform the setting.
When a sequence program used for the MELSEC-Q series A/D converter module is utilized to configure the offset/gain
setting, check that this flag is used as an interlock.
For the sequence programs for the MELSEC-Q series A/D converter module, refer to the following.
 Channel Isolated Analog-Digital Converter Module/Channel Isolated Analog-Digital Converter Module (With Signal
Conditioning Function) User's Manual
'Module READY' (X0)
'Offset/gain setting mode status
flag' (XA)
'User range writing request' (YA)
■In the normal mode
In the user range setting restoration, use Offset/gain setting mode status flag (XA) as an interlock condition to turn on and off
'User range write request' (YA).
For user range setting restoration, refer to the following.
Page 88 Backing up, Saving, and Restoring Offset/Gain Values
ON
'Module READY' (X0)
'Offset/gain setting mode status
flag' (XA)
'User range writing request' (YA)
CH1 to CH16
XA
Controlled by the A/D converter module
Controlled by the program
OFF
ON
ON
OFF
Controlled by the A/D converter module
Controlled by the program
ON
ON
ON
OFF
OFF
OFF
OFF
APPX
119
Appendix 2 I/O Signals
A